![]() and ran it last night to copy 1Tb from a backup disk to one of the new data drives. My laptop is running Windows 10 64-bit, Bvckup v76.12, the PC running Windows XP 32-bit. This made no difference, ie, a single job runs OK, on its own, but I cannot run them concurrently (one job fails with the error message “Scan of source location failed ). I have 2 installations of Bvckup 2 Personal Use. Is there a simple way of re-setting this? I have read, but other than using the restore method, I can’t see a simple way to clear this, if I want to. Delete everything from the %LocalAppData%\Bvckup2 folder and extract contents of this zip file there.Īs a matter on interest, there was over 1Gb of data in the Bvckup folder, ~ 59000 items. (I had to stop the process in Windows Task Manager/Processes to give me access to the files).Ģ. I restored Bvckup 2 configuration from an archive, as instructed:ġ. Subsequent jobs are also saved to this location, hence the issue with them not being saved on exit/restart. The new, working job (probably an existing one, edited) was saved to “C:\Documents and Settings\Mark\Local Settings\Application Data\Bvckup2\engine\backup-0001”. One job fails with the error message “Scan of source location failed”. I create another new job, same log window message. I create a new backup job, and immediately the log window says: “The log file cannot be displayed. I did create a new job after the re-build, and ran it last night to copy 1Tb from a backup disk to one of the new data drives. ![]() At its current copy rate, it will probably take about 2.5 - 3 hours to copy my 800GB of data. ![]() I installed SyncBackFree and am running it now to copy my entire D: drive to my E: drive. I can’t determine if this is an issue to Bvcup 2, but you should be aware. So I decided to try tg550s method of using SyncBackFree to mirror my data drive once a day instead of in realtime. Note that the 2 new drives are 3Tb drives, and on a Windows XP 32-bit PC, I had to use a bit of jiggery-pokery to get the drives to be available at their full 3Tb. However, after making some hardware changes to my PC, I cannot (consistently) create new jobs that are saved between exiting and restarting.Ģ new data drives added, other drives shuffled about, drive letters re-set to original.Įxisting backup jobs work OK, including to/from new data drives, concurrently. The laptop runs fine backups run concurrently, I can create new jobs, the log files are available. My laptop is running Windows 10 64-bit, Bvckup v76.12, the PC running Windows XP 32-bit, Bvckup v76.12.1 (ref. I noticed that 're-copying' behavior a few days ago, when I tried to backup a renamed file, and suddenly saw the process was taking much more time than needed, as. ![]() This most likely indicates a flaky component on a path from bvckup2 to the storage device. But if that option is set to re-scan, then renames will be detected only using the triplet method. I have 2 installations of Bvckup 2 Personal Use. '87' is 'The parameter is incorrect.' Getting this from GetOverlappedResult function is not common at all, especially if it happens now and then. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |